Focus on CNC Laser manufacturing over 10 years,
More than 10,000 customers choose Dekcel.

24 hour service hotline
CNC knowledge
Home > Support > CNC knowledge >

CNC knowledge

How To Install CO2 Laser Tube of CNC Laser Cutting Machine?

Firstly, connect the water pipe to laser water chiller, adjust the outlet water pipe position according to the principle of laser water flowing from lower position to higher position direction Ensure the laser water is full of the laser tube and don’t have bubble Then, open the laser power supply

How To Install CO2 Laser Tube of CNC Laser Cutting Machine?

cw5000 series water chiller of laser tube

Firstly, connect the water pipe to laser water chiller, adjust the outlet water pipe position according to the principle of laser water flowing from lower position to higher position direction. Ensure the laser water is full of the laser tube and don’t have bubble. Then, open the laser power supply.

co2 laser cuting machine tube

Notice:
(a) The laser cooling water is distilled water or pure water, the temperature should be 20-30. In summer, the water temperature is high, should change the laser water chiller or stop the machine for a while. In cold area, don’t let the water freezing, especially don’t let the water stay in laser tube if the laser machine not work.

(Attentions: customers who use alternating current must let the water box grounded).

 
(b) The two fixture should be installed in the 1/4 position of laser tube head. And the volume of water flowing is 2L-4L/min, if not, the cooling water effect is not good. It will let the coating of the tube easy fall off. Beams not focused and decrease the laser power. The nozzle of cooling water in chiller must be covered underwater. If not, the laser tube cannot full with water when next start.
 
(c) Please pay attention to protect the laser output window to avoid smoke sputtering during working as well as adjusting light path. When the laser output window is polluted, the laser power will be decreased. So please use absorbent cotton or cloth dipped in alcohol without water to clean the surface of laser output window.
 
(d) Please use laser tube reasonably. The laser tube is used by the right ways, which will save laser power. In fact, the optimal laser power is only 80% for itself.

CO2 laser tube laser cutting and engraving machine

CONTACT DEKCEL

DEKCELCNC

Address:E-15, Huaqiang International, Shanda Road, Lixia District, Jinan, Shandong,China

Tel:+86-13356681090

E-mail:info@dekcelcnc.com

Website:www.dekcelcnclaser.com

Live Chat
+86-13356681090