Focus on CNC Laser manufacturing over 10 years,
More than 10,000 customers choose Dekcel.

24 hour service hotline
CNC knowledge
Home > Support > CNC knowledge >

CNC knowledge

Operation Procedure of CNC Fiber Metal Laser Cutting Machine

In order to ensure the reliable operation of the500w 1000w 2000wfiber metal laser cutting machine, extend the service life of the fiber laser machine equipment, and improve the quality of the product, should strictly abide by the operation procedures

dekcel cnc fiber metal cutting machine

In order to ensure the reliable operation of the laser cutting machine, extend the service life of the equipment, and improve the quality of the product, should strictly abide by the operation procedures.

Operation Procedure of CNC Fiber Laser Cutting Machine 

1.Open the general switch of the regulated power supply, switch the output voltage to the voltage regulation mode

2.Switch on the main power switch of the machine(machine,water chiller,compressor,machine control system ect)

3.Switch on the power of the machine tool.

4. Wait for the system to complete the self inspection, each axis of the machine back to the reference point.

5.Power on the water chiller,Check the water temperature, water pressure (normal pressure for 5 bar).
fiber metal laser cutting machine water chiller

6.Open the nitrogen gas bottle, oxygen bottle, check the pressure of the gas cylinder, start the air compressor, air dryer machine.

Attention: air compressor, air dryer machine filter must be drained every morning,  the front filter of the outer light path‘s lens side must be checked at any time, no water or oil, or else pollution lenses. Air source must be improved to make it up to the standard.
dekcel cnc screw air compressor

7.Waiting for the water machine lower to set temperature (set to 21 degrees), then open the total power supply of the laser source

8.Before start cutting,confirm material type, material thickness, material size .
   Attention: check the nozzle of the laser cutting head,make sure it clean and not loose

9.Adjustment of the plate, so that the material’s edge parallel machine tool X axis and Y axis , to ensure that the cutting head within the scope of the plate.
dekcel cnc fiber laser cutting machine show

10. Moved the Z axis to the starting point,simulation program to be executed, to ensure that there will not be limit alarm of beyond the software, then into the editing mode, depending on the type of material and thickness setting power, speed & drilling time.

11.The processing is completed, according to the following procedure to shutdown machine
  
 1) Switch off the power of the laser source
     Attention: the laser source with high temperature,need cold down 5~10minutes,then   
              power off the chiller.
   2) Switch off the power of water chiller
   3) Switch off the power of the machine control panel
   4) Switch off the main power of the machine
   5) Switch off the compressor,air dryer.
   6) Switch off the general switch of the regulated power supply


CONTACT DEKCEL

DEKCELCNC

Address:E-15, Huaqiang International, Shanda Road, Lixia District, Jinan, Shandong,China

Tel:+86-13356681090

E-mail:info@dekcelcnc.com

Website:www.dekcelcnclaser.com

Live Chat
+86-13356681090